Plumbing and Water Pump
Water pump area cleaned up - External water source and drainage hole in the middle of the picture.
Water pump area different angle.
Sinks with sound deadener applied.
Water pump and accumulator installed on rubber vibration bushings and floor fiber glassed.
A different angle 01.
A different angle 02.
Started installing pex to/from the water tank. I placed 1" pvc into all the holes in the floor so in the event of a leak (if I'm lucky) I could prevent water going down into the battery/circuit breaker area directly below.
Added the 90 degree bends to keep the pex in place.
A different angle.
A lot going on in this space. Upper valve handle when pointing to 3:00 o'clock allows the water pump to feed the faucet from the water tank. Bottom valve hand when pointing to 3"00 o'clock allows water from outside to fill the water tank.
A different angle 01.
A different angle 02.
A different angle 03.
A different angle 04.
I used 1/2” pex but apparently you can use 3/8” and it’s a lot easier to work with.
In the picture “A different angle 03.” you can clearly see the ON / OFF text on the valve handle.
A check valve is installed on the water hook up line.