Cabinetry
Generic frame components 01.
Door face components 02.
Door components 02.
Door components 03.
Door components 04.
Door components 05.
Door components 06.
Door components 07.
Door components 08.
Door components 09.
Door components 10.
Door components 11.
Door components 11.
Door components 12.
Door components 12.
2 drawers below the dining table.
Propane compartment wrapped in Reflectix. The linoleum floor is so hideous/blemished that I actually like it. Covered up with carpet so as not to implicate the guilty/lazy.
Passenger side where the 2 drawers go. Wiring from the Commode area where the Diesel Heater and Electrical outlet will be fed along with hydraulics and water tank drainage line secured for installation of drawers.
I used a single sheet of plywood from the Refrigerator to the Cab Over, routed the edges out and then used brass screws to secure the paneling (all covered in blue painters tape). Adding the painters tape was a mistake as there was some transfer of adhesive which darkened the wood somewhat
Another angle 01.
2.7mm plywood - Cheap but a bit fragile (Home Depot approximately $18 a sheet however the Pandemic interrupted stock availability and pattern continuity)
Another angle 02.
Another angle 03.
Original plastic front drawers 01.
Original plastic front drawers 02.
Original plastic front drawers 03.
Original front drawer space 01.
Original front drawer space 02.
Original front drawer space 03.
Space cleaned up and ready for new self closing drawers 01.
Sliding drawers replaced the plastic insert drawers to maximize depth
Space cleaned up and ready for new self closing drawers 02.
Space cleaned up and ready for new self closing drawers 03.
Space cleaned up and ready for new self closing drawers 04. Waiting for version 2 of the counter top after deciding to replace the stove with a 2 burner unit
Current counter top configuration including food storage and Inverter/MPPT space now that the original oven has been replaced by the 2 burner stove top. Laminate was sourced from Home Depot.
Cabinet outer paneling.
Cabinet inner paneling.
I basically ended up using the frame pieces and added my paneling to both the exterior and interior sides of every drawer, door and surface secured by brass screws.