Hydraulics
Drivers side rear hydraulic area cleaned up and ready for valve.
Another angle 01.
Another angle 02 - Oven to be removed for a 2 burner stove top.
Drivers side hydraulic areas cleaned up and ready for valves.
Drivers side front hydraulic area cleaned up and ready for valve - sliding drawer rails starting to go in. In every one of the four corners the pistons were at different heights from the floor.
Passenger side front hydraulic area cleaned up and ready for valve - Water Tank inlet lines will be going into the tank at the forward wall.
Passenger side frot hydraulic piston area posed a challenge due to the lid of the water tank area.
Upper piston hardware.
Upper piston mounting bracket generic 01.
Upper piston mounting bracket generic 02.
Deltrol-Easy-Read
Deltrol-Easy-Read
Passenger side rear valve installed in storage compartment with Diesel Heater distribution ducting.
Passenger side front valve next to fresh water tank installed.
Drivers side front valve installed next to lower sliding drawer (removed for picture).
Drivers side rear valve installed just forward of Hydraulic pump and aft of the T.
Adding controllable (in 1 direction) valves to try and work out getting the upper half to raise and lower in a balanced fashion.
Here’s a link to how these valves work : https://www.youtube.com/watch?v=iFlPta8vaIk